1. Close the bathtub/shower drain or cover it with cloth. Take bottle (TubSafe® Treatment) and  slowly pour the entire content at the rear base (bottom) of the tub or the back of the shower. Using the white applicator, slowly spread solution across the entire base (bottom) of tub/shower for 5 MINUTES (do not let a puddle to form by drain). DO NOT APPLY TO UPWARD CURVE (SIDES) OF THE TUB/SHOWER. Keep the treatment moving slowly and evenly across the entire bottom of the tub/shower. No need to push down hard. 

2. Open the drain, Fill a cup (or turn on shower and spray) with water and immediately pour over the  treated area. This will activate the TubSafe® Neutralizer that is encapsulated within the treatment. Refill the cup with water or continue shower and slowly flush water around the entire base (bottom) of the tub/shower to remove all of the anti-slip treatment and neutralizer. Rinse out empty bottle with water**. Replace in TubSafe® Tray (commercial clients) and proceed to next installation. Dispose of all materials properly!     

UPON COMPLETION: While the tub/shower bottom is wet, step into it with bare feet or using the palm of your hand, slide/push with pressure across wet surface. Your feet or hand will resist sliding/slipping. The harder you push the more the anti-slip treatment will resist sliding/slipping! This is the result of a correct installation.